We make The best bridge rectifier in the world, probably. 😉

Saligny is a diode-less bridge rectifier employing modern MOSFET’s. The result is an active bridge that replaces the four diodes in a full-wave bridge rectifier with a mili-ohm Rdson MOSFET, to drastically reduce power dissipation, heat generation, voltage loss and diode on/off switching noise. There is no P-N junction involved, only a low miliohm conductive channel get inserted in power path. This allow big current capability, better power management, less power loss, less dynamic impedance change versus load current and better circuit performance than any available rectifier solution.

While a normal diode have at least 600mV drop at 1A, a low Rdson MOSFET will have as little as 3mV, or less, at same 1A. This is 200 times better than a PN diode and at least 100 times better than a Schottky diode. 

Applications:

  • ultra low noise power supply (LC, Standard and HVHF)
  • high-end audio (LC, Standard and HVHF)
  • high-voltage rectification in valve amplification (HVHF)
  • smps input and output rectification (HVHF)
  • power-over-ethernet devices (LC, Standard)
  • polarity-agnostic input devices (LC, Standard)
  • diode bridge replacement (LC, Standard and HVHF)
  • PoE – Power over Ethernet powered devices
  • Green devices

Benefits

  • Environmentally friendly
  • Increased efficiency
  • Reduce EMI
  • Highest power density
  • Smallest board-space consumption
  • Easy-to-design products

Disclaimer:
We take no responsibility for the fact you will never want to use again a diode bridge in your application. Please note that our products create dependency. 🙂

Related links:

SALIGNY LC
Status - in stock

Saligny LC - low current - offer very small solution size - 10 mm x 10 mm while keeping same Synchronous Rectifie features.

Features:

  • Smaller solution size – Saligny LC is only 10mm x 10mm.
  • Maximises power efficiency.
  • Maximises available voltage and current.
  • Eliminate power thermal design problems.
  • No need for a heatsink.
  • Zero switching noise.
  • No secondary ringing in the transformer like PN or Schottky diodes.
  • If power source fails or is shorted a fast turn-off minimizes reverse current transients.

Specifications:

  • Operates from DC to 600Hz.
  • AC operating voltage 6Vac to 30Vac.
  • DC operating voltage 9Vdc to 42Vdc.
  •  Iq = 1,5mA.
  • Continuous load current up to 5A.
  • Peak 8A – 500ms.
  • Require a minimum output capacitor of 470uF
  • Do not support centre tapped transformer.

Price: 30 euro, ex VAT

Mail us at office@evotronix.eu for custom orders.

Discount for orders higher than 10 units.

Shipping within EU is 22euro and 38euro outside EU. 

We accept bank transfer and PayPal.

SALIGNY Standard
Status - in stock

Saligny Standard is our Synchronous Rectifier solution for most common applications. It is available in a small footprint 32mm x 28mm

Features:

  • Smaller solution size 32mm x 28,2mm – Saligny is smaller in size than equivalent diode bridge.
  • Pin compatible with standard rectifier
  • Maximises power efficiency.
  • Maximises available voltage and current.
  • Eliminate power thermal design problems.
  • No need for a heatsink.
  • Zero switching noise.
  • No secondary ringing in the transformer like PN or Schottky diodes.
  • If power source fails or is shorted a fast turn-off minimizes reverse current transients.

Specifications:

  • Operates from DC to 600Hz.
  • AC operating voltage 6Vac to 51Vac.
  • DC operating voltage 9Vdc to 72Vdc.
  • Iq = 1,5mA.
  • Continuous load current up to 20A or more depending on mosfet configuration.
  • Over 200A pulsed current at Ta = 25Celsius ( Max Rθjc = 1.0C/W, pulse duration ≤100 μs, duty cycle ≤1%).
  • Require a minimum output capacitor of 1000μF
  • Do not support centre tapped transformer.

Price: 45 euro, ex VAT

Discount for orders higher than 10 units.

Shipping within EU is 22euro and 38euro outside EU. 

SALIGNY Power
Saligny Power
Status - in stock

Saligny Power - continuous load
up to 60A output. Operate from 8 Vac up to 51 Vac and up to 100Hz. It is available with Aluminium substrate, offering exceptional heat dissipation

Features:

  • Optimised for computer/server linear power supply
  • Maximises power efficiency.
  • Reduce EMI
  • Maximises available voltage and current.
  • Eliminate power thermal design problems.
  • Up to 25A no heatsink needed.
  • Made on aluminium substrate
  • Zero switching noise.
  • Lower secondary ringing in the transformer secondary.

Specifications:

  • Operates from DC to 100Hz.
  • AC operating voltage 8Vac to 51Vac.
  • DC operating voltage 10Vdc to 72Vdc.
  • Iq = 1,5mA.
  • Continuous load current up to 60A or more with heatsink.
  • Over 350A pulsed current at Ta = 25Celsius ( Max Rθjc = 1.0C/W, pulse duration ≤100 μs, duty cycle ≤1%).
  • Mounting force 1.13 / 10 Nm/lb.in
  • Require a minimum output capacitor of 4700μF (low ESR)
  • Do not support centre tapped transformer.

Price: 69 euro, ex VAT

Discount for orders higher than 10 units.

Shipping within EU is 22euro and 38euro outside EU. 

SALIGNY HVHF MKIII
SalignyMKII
Status - in stock

Saligny HVHF MKIII - high voltage high frequency, operate from 20Vac up to 320Vac and up to 200KHz - full wave. It is available in a 4 layer PCB with small footprint 45mm x 32mmHVHF

Features:

  • Optimised for valve/tube applications and SMPS input.
  • Smaller solution size 45mm x 32mm
  • Pin compatible with standard diode rectifier
  • Maximises power efficiency.
  • Maximises available voltage and current.
  • Eliminate power thermal design problems.
  • No heatsink needed.
  • Zero switching noise.
  • Lower secondary ringing in the transformer secondary.

Specifications:

  • Operates from DC to 400KHz
  • AC operating voltage 20Vac to 320Vac.
  • DC operating voltage 24Vdc to 450Vdc.
  • Iq = 20mA.
  • Continuous load current up to 4A.
  • Over 25A pulsed current at Ta = 25Celsius
  • Require a minimum output capacitor of 47uF
  • Support centre tapped transformer.

Price: 109 euro, ex VAT

Discount for orders higher than 10 units.

Shipping within EU is 22euro and 38euro outside EU. 

SALIGNY Universal
Saligny Universal

Coming in April 2023 ! 
Saligny Universal - is a discrete synchronous rectifier that support centre tapped transformer for symmetrical power supply.

Specifications:

  • Operates from DC to 100Hz.
  • AC operating voltage 6Vac to 60Vac.
  • AC operating voltage 2 x 4Vac to 2 x 30Vac.
  • DC operating voltage 12Vdc to 80Vdc.
  •  Iq = 9mA.
  • Continuous load current up to 18A.
  • Over 200A pulsed current at Ta = 25Celsius ( Max Rθjc = 1.0C/W, pulse duration ≤100 μs, duty cycle ≤1%).
  • Peak 60A – 500ms.
  • may operate without an output capacitor, but not recommended.
  • Support centre tapped transformer.
Saligny Power GaN

Coming soon ! 
Our most advanced synchronous bridge full wave rectifier, that is based on highly efficient GaN (Gallium Nitride) transistor technology over a teflon substrate.

Specifications:

  • Lowest noise rectifier available on market.
  • Operates from DC to 1000Hz.
  • AC operating voltage 5Vac to 140Vac.
  • AC operating voltage 2 x 2.5Vac to 2 x 70Vac.
  • DC operating voltage 5.6Vdc to 200Vdc.
  • Iq = 9mA.
  • Continuous load current up to 100A.
  • Over 450A pulsed current at Ta = 25Celsius ( Max Rθjc = 1.0C/W, pulse duration ≤100 μs, duty cycle ≤1%).
  • may operate without an output capacitor, but not recommended.
  • Support centre tapped transformer
SALIGNY 3Phase

Coming soon !
Three phase synchronous rectifier. It is available with Aluminium substrate, offering exceptional heat dissipation

Specifications:

  • Operates from DC to 1000Hz.
  • AC operating voltage 9Vac to 70Vac.
  • DC operating voltage 12Vdc to 100Vdc.
  • Iq = 12mA.
  • Continuous load current up to 60A or more with heatsink.
  • Over 350A pulsed current at Ta = 25Celsius ( Max Rθjc = 1.0C/W, pulse duration ≤100 μs, duty cycle ≤1%).
  • Screw mounting force max.1.13 / 10 Nm/lb.in
  • may operate without an output capacitor, but not recommended.
    • Support centre tapped transformer.
Zeno MKIII
Zeno MKIII

Ultra low noise regulator based on LT3042 and synchronous rectifier Saigny Standard. Max input voltage is 14Vac.
Output, any voltage between 0Vdc and 15Vdc at max. 6A.
For operating at 6A a heatsink is needed, but not included..

We sell Zeno MKIII as a custom product. Output voltage is adjustable between 0Vdc and 15Vdc.

Price is 139euro ex.VAT. 

Specifications:

  • TBA
  •  

Zeno MKII is our next ultra low noise regulator based on LT3042 and synchronous rectifier Saigny LC. Max input voltage is 14Vac.
Output, any voltage between 0Vdc and 15Vdc at max. 4A.
For operating at 4A a heatsink is needed, but not included..

We sell Zeno MKII as a custom product. Any voltage between 0 and 15V is possible.

Price is 99euro ex.VAT. We accept orders by mail. Please mention input voltage and desired output voltage and current. Shipping within 48h.

Active Power Supply

Dual active power supply, based on Saligny Standard. This may output between +/-9Vdc and +/-72Vdc, as long capacitors are properly chosen and operating voltage is above output.  

We offer PCB at 25euro ex.VAT

Schematic -> 

BOM -> BOM_PS

Single active power supply, for use in server applications. This may output between 9Vdc and 72Vdc, as long proper voltage capacitors are selected. We offer PCB at 25euro ex.VAT.

Schematic –>

Gerbers –> Server power supply

BOM –> PS_Server

 


We offer option to buy directly from our website and you may pay by credit card or paypal. You may also order by email at office@evotronix.eu . In this case, we invoice you and you may pay by bank transfer as well.

Please contact us if you do not find what you are looking for. We are happy to bring our experience into your product, or to design a custom synchronous rectifier for your application. We offer our service from an idea to the final product.

All products are hand-made and each component is carefully tested before shipping. 

If you are looking for customer feedback, please browse and read real customer experience from diyaudio group buy: link to 1st group buy, 2nd group buy, 3rd group buy.

All orders are shipped via Posta Romana with tracking. We ship within EU in 48h and for non EU each Tuesday. For other courier services, please contact us prior your order.

About us

Alin Focseneanu – CEO

.

Tiberiu Vicol – CTO

.

Catalin N. – CDO

.

Ioana Focseneanu – CFO

Contact info

Company:

  • EvoTroniX S.R.L.
    EU VAT: RO40877103
    CIF: J29/1396/2019

Address:

  • Strada Ana Ipatescu, Nr. 71, Ploiesti, Romania.

Email us:

  • office@evotronix.eu
  • info@evotronix.eu

Call us:

  • Phone: +407 5 230 3791
  • Signal: +407 5 230 3791
Please check for our replay in your spam or junk folder.
Contact us